Adjusting and changing "v" belt – SINGER W714 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
28
ADJUSTING AND CHANGING "V" BELT
f.' A, r
Fig. 57
Fig. 58
Fig. 59
Following are the instructions for adjusting and changing the "V" belt:
(1)
Open bobbin winder cover dcor Fig. 57.
(2)
Remove three screws holding rear cover (Fjg. 58) by tipping it out at the bottom and
pivoting around the hand wheel away from the front of the machine.
(o) To adjust "V" belt, loosen screws (A, Fig. 59) and move bracket B up to loosen belt and
down to tighten.
(4) To remove "V" belt:
(A)
Remove top cover.
(B)
Loosen clutch (C, Fig. 58).
(C)
Loosen screws "A” (Fig. 59) and move bracket "B" to its highest position.
(D)
Slip belt off motor pulley and then over hand wheel.
(E)
Replace "V” belt by slipping it over hand wheel and then over motor pulley.
(F)
Adjust as noted under No. 3.