SINGER W714 - Manual (Page 7)

1
Fia.
WINDING THE BOBBIN
Fig. 4
Disengage hand wheel (5, Fig. 3), from the stitching mechanism by turning clutch ( 6 , Fig. 3)
toward you or counter clockwise.
Push latch (4, Fig. 4) to spring open cover (3, Fig. 4) of the recessed winder.
Place a spool of thread on one of the spool pins. Lead thread through the upper thread
guioe on arm and down through tension disc (9, Fig. 5,) at base of machine. Run end of thread
through a hole in bobbin edge (left flange
and from inside out) and place bobbin
on spindle of bobbin winder (7, Fig.4j fitting
the notch bobbin over small pin on spin­
dle.
Push bobbin winder against hand
wheel. Hold thread end loosely and start
machine slowly.
Bobbin will stop winding when it is
filled. Turn clutch away from you until
sewing
mechanism is again engaged so
that needle moves when you turn the hand
wheel.
Break off loose thread end used to
start the winding and thread bobbin as
stated on Page
6
--- ( 7 )