Adjusting and changing v belt – SINGER W1166 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADJUSTING AND CHANGING V BELT
Following are the instructions for adjusting and changing the "V" belt:
(11 Remove three screws holding rear cover (Fig. 58) by tipping it out at the bottom and
pivoting atound the hend wheel eway from the front of the machine.
To adjust "V" belt, loosen screws A, Fig.
. and move bracket B up to loosen belt and
down to tighten.
To remove "V" belt:
(A ) Remove top cover.
Loosen clutch C, Fig. 58
Loosen screws "A" (Fig. 59) and move bracket "B" to its highest position.
(D) Slip belt off motor pulley and then over hand wheel.
Replace "V" belt by slipping it over hand wheel and then over motor pulley.
Adjust as noted under No. 3.