SINGER W1166 - Manual (Page 48)

r
» »V
PLAIN BOUND BUTTONHOLE
Cut straight or bias strips of fabric 2"
wide and 1" longer than the desired but­
tonholes. Place right sides together over
positions for buttonholes. Mark exact length
of each buttonhole in center of each strip; place
a pin through center of the marking. Begin
to stitch at the pin; marking an oblong box
Ys" above and below the line; Vi" across
each end. Run a few stitches beyond start­
ing point to reinforce. View 1.
Slash through the center line of the box
to within YY’ of each end, then diagonally
into each corner, View 2. Turn the strip
through the opening, press seams flat across
the ends so the facing will not be visible
from the right side. Told the strip to meet
in the center of the opening. Baste the folds
together across the opening, View 3.
Turn garment back at each end and stitch
across the strip, securing the triangular slash­
ed section to the pleated strip and press. View
4. Bring facing of garment to position and
baste around each buttonhole. Insert the
point of a pin through each corner and slash
through the center and into each corner prn
Turn under the raw edges and slipstilch
the facing to the underside of the buttonhole.
View 5. Press the finished buttonhole. View
6
.
V I E W 1 V I E W 2
V I E W 3
V I E W 5
V I E W 6