Setting the needle, Threading the bobbin case – SINGER W1166 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SETTING THE NEEDLE

See Fig.

6

. Raise the needle bar A to its highest

point, turning wheel toward you by hand.

Then loosen the needle clamp screw B and the

needle can be inserted into clamp C. Place needle

(flat side to right) in the needle clamp and push it

upward as far as it will go into the needle clamp
hole, tightening the needle clamp screw securely
with a screw driver.

After changing the needle make one com­

plete

revolution

of

the

balance

wheel

by

hand to be sure the needle is in the correct

position.

Fig.

6

Fiat surface

of needle
shank

Fig. 7

THREADING THE BOBBIN CASE

Step 1 i.illustrated in Fig.

8

,). Hold bobbin case between thumb and forefinger of left hand,

so that the slot in the edge of the bobbin case is on top. Take the bobbin between thumb and

forefinger of right hand so that the thread on top leads from left to right.

Step 2 Insert bobbin into bobbin case, pull the thread into the slot of the bobbin case as

shown in Fig. 9, and draw it under tension spring and into the fork-shaped opening of the spring
as shown in Fig. 10.

•c.
e~

c-

■I! № ■

Advertising