The set of hemmers, Hemmer set – SINGER W1166 User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
38
THE SET OF HEMMERS
Before attaching any of the hemmers. Be sure
bobbin thread is pulled up. Then, with hemmer in
place, hold top thread loosely and turn handwheel one
full turn toward you, making a loop under hemmer.
Grasp bobbin thread with both hands and shp
horizontally under hemmer toward back. Bobbm
thread will catch loop and carry upper thread to back
of hemmer.
Fold mateiial to suit for two inches along edge,
ut. Fold hem to n.lri.1 bach of hemmer. I’”"
and fasten with point of needle. Pull on threads gently as you start strtchx g.
Fig., 71
H E M M E R S E T
You can make a hem 1/4', 3/8', 5/8' or 7/8' in width, depending upon
which hemmer you use. For a few of the m.nv uses see Fig. 72, 73, 74, 7b,
76 and 77.