Threading the needle eye, Drawing up the bobbin thread – SINGER W1750C User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THREADING THE NEEDLE EYE
1 .Lowerthe presserfoot.
2.Set needle in up position.
3.Lower the threader slowly and draw
thread through thread guide (A) and
pull toward the right.
4. Lower the lever as far as it will go
The threader will turn and the hook
pin will go through the needle eye.
5. Draw thread through the lower
guide.
6. Hold thread loosely and release the
lever. Hook will turn and pass
thread through needle eye while
making a loop.
7. Pull thread out about 10 inches from
needle eye.
Note: The needle threader is used for
needle sizes 11,14, and 16.
CAUTION: To prevent accidents.
Do not lower the threader lever while machine is operating.
DRAWING UP THE BOBBIN THREAD
1 .Raise the presser foot.
2.Hold the upper thread loosely and
press needle up/down button twice.
The hand wheel will turn one complete
turn.
S.Pull upper thread lightly. Bobbin thread
will come up in a loop.
4.Pull both upper and bobbin threads about
10 inches toward the back of presser foot.
-
14
-