SINGER 610U User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
If
bobbin
does
not
wind evenly—
Loosen screw which holds
tension brocket in posi
tion.
Move
bracket
up
if bobbin winds towards
bottom.
Move
bracket
down
if
bobbin
winds
towards
top.
THREADING THE BOBBIN CASE
1. Hold bobbin so that thread leads
off in direction shown.
2. Place bobbin in case.
Lead thread into slot and under
spring.
3.
Draw thread into notch at end
of spring ; pull about 3 inches of
thread across bobbin.
4. Close slide plate allowing thread
to enter notch.
Advertising