SINGER 610U User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BUTTON SEWING FOOT
'i
• Stitch Pattern Selectors:
AJ
• Stitch
Width
Selector!
1
and about
4
• Throat Plate t General Purpose
• Presser Foot:
Button Sewing Foot
• Lower Feed
The space between the holes in the button deter
mines the stitch width settings. The number 1 setting
must always be used to position the needle and fasten
stitching. For buttons with standard hole spacing, use
settings
1
and
4.
For buttons with unusual hole spacing,
use setting 1 and increase or decrease the width setting
(4)
as necessary.
..............Si
I
I
. .
’ 'S
!-S; ■ S "
Set selectors at AJ and stitch width
at 1. Lower feed. Position button ;
under
foot
so
that
needle
will
enter left hole. Lower foot. Turn
hand
wheel
toward
you
until
needle rises out of fabric and is
just above the foot.
%
Set stitch width at about
4.
The
needle should then enter into the
right hole of the button. Take ap
proximately
six
zigzag
stitches
in
this position. End on the left side.
To fasten stitching, adjust to num
ber
1
stitch
width
setting
and
take opproximately three stitches.
THREAD SHANK
In order to form a shank, stitch over a regular ma
chine needle. Position button and lower Button Sewing
Foot. Place needle in the groove of the foot so the
point enters the hole.
To form a long shank, stitch over the heavy end of
the needle.
35