SINGER 610U User Manual

Page 27

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CHAIN STITCHING (Continued)

TO THREAD THE MACHINE

Thread your machine in the usual way, except pass

needle thread from take-up lever through chain stitch

thread guide

D

with the face plate open. (See Fig. 6)

NEEDLE THREAD TENSION

Normally set between 2 and 4 on the Tension Dial,

however, slight adjustment may be required dependent

on the thread size and the material used.

When the tension is correctly adjusted, the chain will

be flat and smooth. (See Fig. 1)

Puckers in the fabric and pinched loops indicate too

much tension—turn dial to a lower number.

Large, irregular loops indicate too little tension—turn

dial to a higher number.

^

t .

- T'

.''1

TO

SEW AND CHAIN-OFF

• Stitch Pattern Selectors :

• Stitch Width Selector:

•Stitch Length:

6'—12

• Throat Plate:

• Presser Foot:

2

.

AN

3

Chain Stitch Throat Plate

Straight Stitch or General Purpose

(When sewing soft fabric with fine

thread)

Special Purpose

(When sewing crisp fabric such as

calico with #50 cotton)

1. Position needle in very edge of fabric and lower the

presser foot.

Start the machine and stitch to end of seam. Con­

tinue stitching beyond edge of fabric, making a chain

from one to two inches long.

Cut chain between fabric and presser foot. (See Fig. 9)

After chaining off, start a new line of stitching by

raising the presser foot slightly and positioning the

fabric in front of needle. Lower presser foot and

stitch to end of seam. (See Fig. 10)

Fig.

Fig. 10

25

Advertising