SINGER 610U User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
^ :
TO CHANGE THE NEEDLE
1
.
Raise needle bar to highest position by turning hand
wheel toward you.
2.
Loosen the needle-clamp screw and remove the
needle.
3.
Insert
new
needle in clamp, with the flat side of
the needle to the back and the long gfsova toward
you; push it up as far as it will go.
4. Tighten needle-clamp screw.
This machine uses needles
Catalog 2020 (15X 1)
Sizes 9, n, 14, 16 and 18.
TO HOLD SPOOLS ON HORBZONTAL SPOOL PIN
Remove
spool
holder
A
from
spindle
by
sliding
in to the left.
Slip
spool
onto spindle.
of thread
To
hold
small
spools—
Turn small end of spool
holder
to
the
right
and
slide
onto
spindle.
Press
spool holder firmly against
spool.
To
hold
large
spools—
Turn
wide
end
of
spool
holder
to
the
right
and
slide
onto
spindle.
Press
spool holder firmly against
spool.
SMALL SPOOL HOLDER
A small size spool holder
S
is furnished with the
machine. This spool holder lets thread unwind smoothly
when very small spools wound with embroidery thread,
etc. are retained on the spool pin.
VERTICAL SPOOL
This spool pin is used when two-needle stitching is
desired. For instructions, see page
22
,