SINGER 610U - Manual (Page 39)

HOW TO USE THE EDGE-STITCHER IContinoed)
TO MAKE A FRENCH SEAM
1. To make a French seam of uniform width, insert
two edges to be joined, wrong sides together, in slot
1 or 2, and stitch close to edge.
2. Fold both right sides together and insert back of
seam in slot 1, as shown in sketch at left and stitch,
allowing just enough margin to conceal raw edges.
TO TUCK WITH EDGE-STITCHER
1. Fold and crease material for desired width of tuck,
2. For succeeding lucks, fold material the desired dis­
tance from previous tuck, running the fold length­
wise over a straight edge, then crease folds.
3. Insert creased folds in slot T and 2 and adjust edge-
stitcher to right or left for the desired width of
tuck. Use a light tension, short stitch and fine
thread and needle.
OVERLAP SEAM
1. Fold edge of a piece of material and insert it in
slot 1.
2. Insert another piece of material in slot 5.
3. Set stitch pattern selectors at "BJ” and stitch width
selector at 2 or 3, and proceed to stitch.
37