SINGER 1371A2 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5) Passing belt shifter
®
of the speed transmitter, attach the belt onto tension pulley d).
6) Put fixing pawl @ in the second groove from the bottom of ratchet © to provide the
belt with tension.
(NOTE) Some expansion or contraction in the belt caused by temperature or humidity
may make it rather difficult to install the belt. However, the belt will restores its
original length while in use.
5,
5. INSTÀLLÀTION/REMOVÀL OF BELT COVER Fig.6
Aligning guide pin @ with hole ® in belt cover ®, push the belt cover in the arrow
direction until it snaps.
For removal of the belt cover, bring down the belt cover in the direction opposite to the
arrow, and slide it up.