' adjusting the overedoing lengthibunonhole lengi, 3) -nls.m, -№№ij]m]]7pmwl№i, Iiaismi!i@*is«w«-!5igisikijiw«ai – SINGER 1371A2 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
^17.' ADJUSTING THE OVEREDOiNG LENGTHiBUnONHOLE LENGi^
2) ffi »#«?№&«# ®,
fflffi ®±ff
. (-iaWZI «a« 1^
«ijs
it»!®«®.
3) -nLS.m,
-№№ij]m]]7pmwL№i^^.
*
ffiSftSWiSffl
iiaiSMi!i@*is«w«-!5igisiKijiw«ai#.
GM344/10
l/4"~3/4"
GM347/10
1/4"~1"
GM348/10
l/4"~ 1—1/4"
1) Pull out cover ®, and raise cover ®.
2) Loosen nut ® by the spanner supplied with the machine. Set point ® to a desired
length on scale ® (this length is the same with the knife width), and then retighten
nut®.
3) Through your trial sewing, adjust the overedging length accurately to the exent that
the bar tacking seams are not cut by the knife.
22
Advertising