SINGER W166 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PLACING BOBBIN CASE IN SHUTTLE
Open hinged cover ¡jlate left of the needle
(See 11, Fig. 1) Flold the bobbin case latch, (D)
F.g. between the thumb and forefinger of thi left
and, with at least three inches of thread running from
le op of the bobbin case to the right. Insert and center
he bobbin case on the stud of the shuttle body, (C).
Be sure the bobbin
case
finger,
(E),
enters
the
shuttle
race notch, (A).
Press the bobbin case
(B) into the shuttle
as far as possible until
latch catclies on the
center
post
of
the
9
shuttle.
THEN release the bobbin case latch,
(D)
Press bofibin case again after latch has b^en released to
make sure the bobbin case is locked securely i„ place,
Close the cover plate.
Fig. 10