SINGER W166 - Manual (Page 24)

22
Remove the toothpick and wind thread under button,
forming a shank. Fasten.
Apply the above method to sew on buttons with four
holes, hooks, and snaps, etc.
If a four hole button is to be sewn, follow the same
procedure above for the two hole button.
Now lift presser foot slightly and move fabric to permit
stitching the remaining two holes.
Hooks, snaps, etc., are sewn to the fabric with the
same procedure as for sewing two hole buttons.
HOW TO USi ACCESSORIES
Fig. L'H
NARROW IIEMMER. With the needle at its highest
postiton, replace regular presser foot with narrow hemmer
(Fig. 28). For a plain narrow hern, make a 1/8 inch double
fold for about two inches along edge of fabric. Hold each
end of the two inch fold, slip underneath hemmer. Bring
fold up into the scroll of hemmer, draw forward to end
and fasten with point of needle. Lower presser bar lifter.
Gently pull ends of thread as you start stitching.
Guide material slightly to right, and it will automatically
take a double turn through scroll.
LACE TRIMMED HEM. To sew a narrow hem
and attach lace in one stitching, insert lace in the slot next
to needle (Fig. 29). Sew hem as above, guiding lace
under needle and hem into scroll.
Fig. 21»
I.
of fahi
Fi
feedinj
F
lower
Fdgcsl
И
the na
Ql
pronge