Darning – SINGER W166 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
19
OM I’LETED
embroidering
with
a
hoop
It is easy to follow a stamped design or to work free
hand when embroidering or monogramniing.
(See Fig. 25). Release the pressure from the foot by
pressing down the snap look on the automatic darner.
Turn drop feed knob to DOWN position (see Fig. 19).
Stretch the fabric in an embroidery hoop, and place
under the needle after removing the presser foot.
Set the stitch width at the size you prefer and lower
the presser bar lifter. Then operate the machine at a rather high speed while moving the
with both hands. Work carefully and be sure to keep fingers out of the path of the needle.
Fig. 25
hoop slowly
m of the
tuse this
DARNING
Release pressure from foot and drop feed as directed above.
Place fabric to be mended under foot, and stitch around hole, moving the fabric firmly and
slowly in any direction. To fill in the hole, stitch from center outward, completing and stitching
in fabric.