Upper threading – SINGER W166 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UPPER THREADING
(Fig. 10)
1) Place spool of thread on upper spool pin,
2) lead thread through arm thread guide A
3) down and around tension discs B from right to left
4) into the check spring C over threaded discs.
5) then pull thread under bar D (See insert, P'ig. 10)
6) up into take-up lever E from right to left
7) down into thread guide P' on face plate
8) tlirough the needle bar thread guide G
9) and into needle from left to right. Pull three or four inches of thread through needle
Mold the end of upper thread loosely and turn hand wheel toward you until the needle goes all the
way down and comes back up. A loop (Fig. 11) will he formed over the lower thread whicli then can be
pulled out straight. Place both thread ends under the slot of the presser foot and draw toward the back
of the machine, leaving both threads three or four inches long.
Fig. 11