SINGER W1240 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING THE BOBBIN
TO REMOVE THE BOBBIN FROM BOBBIN CASE;
Raise neeL bar to its highest position. Bobbin case cannot be
removed when needle bar is at low position.
Open shuttle race cover, pull bobbin case latch with two fingers a d
remove bobbin case as shown above.
Remove bobbin from bobbin case by releasing latch.
r
n
l\
TO ATTACH THE BOBBIN CASE:
• Pull thread at least 3 inches from bobbin.
• Thread bobbin as shown on page
( 7 j.
,
. Making sure that needle bar is at its highest position insert bobbin
case into shuttle race by holding bobbin case latch. Make sure bob
bin case finger is inside shuttle notch. Press bobbin case into shuttle
as far as possible until latch catches on center post of the shuttle.