SINGER 9113 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Your machine comes with the General Purpose Presser Foot (B) already attached You
can easily change to any one of the other presser feet which snap onto a common shank
by following the directions below.
CHANGING THE PRESSER FOOT (B) (D) (E) (J) (L)
• Raise needle to its highest position by
turning hand wheel toward you.
• Raise presser foot using presser foot lifter
in back of machine.
• Push toe of presser foot (1) up, until it
snaps off the shank (2).
• Take foot off machine.
• Place new foot under center of shank.
• Lower presser foot lifter, fitting shank
over presser foot pin (3).
•
• Don’t turn screw. Instead, push presser
foot screw (4) down firmly until foot
snaps into place.