Inserting a wound bobbin – SINGER 9113 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
INSERTING A WOUND BOBBIN
When you want to sew with a bobbin that is already wound, insert it following the
instructions below.
• Raise presser foot.
• Turn hand wheel toward you until needle
is in its highest position.
• Open slide plate completely, and remove
bobbin.
1. Pull 4" (10cm) of thread from replacement
bobbin and insert bobbin, with rings
facing up, into case.
•
2. Holding bobbin in place, guide thread
into notch (1)
3. Bring thread around and past point #2.
4. Holding bobbin thread on outside, leave
slide plate open.
• Follow directions for “Raising Bobbin
Thread”, on page 17.
16
Advertising