SINGER 384.18024 (Sold at Sears) User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
®
Mark for placement of buttonhole
(?) Starting point
(D
Slider
®
There shoud be no gap.
®
Spring holder
®
Difference
Draw both threads to the left under the foot.
Insert the garment under the foot, and lower the needle at the
starting point.
Then lower the automatic buttonhole foot.
* Make sure there is no gap
(D
between the slider © and the
spring holder
®.
If there is a gap
®,
the length of the rows will be different, as
shown in
®.
Sew slowly and stop the machine at the starting point when a
buttonhole is completed.
Remove the fabric and place a pin just before the bartack at
each end to prevent cutting bartacks. Cut the opening with the
buttonhole opener.
After a buttonhole is sewn, move the stitch to the next stitch by
turning the stitch selector in direction of
®
or ©, then return
the stitch back to “ |]’’ to reset for sewing the next buttonhhole.
When finished, push the buttonhole lever up as far as it will go.