SINGER 384.18024 (Sold at Sears) - Manual (Page 7)

GETTING READY TO SEW
Connecting Machine to Power Supply
® Power supply plug @ Power switch
@ Outlet
®
Machine socket
® Machine plug ® Light bulb
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch @.
2. Insert the machine plug © into the machine socket
3. Insert the power supply plug ©into the outlet @ .
4. Turn the power switch©to turn on the power and
sewing light®.
For Your Safety
* While in operation, always keep your eyes on the sewing area.
Do not touch any moving parts such as the thread take-up
lever, handwheel or needle.
* Always turn off the power switch and unplug from the power
supply:
- When leaving the machine unattended.
- When attaching or removing any parts.
- When cleaning the machine.
* Do not place anything on the foot control, when not sewing.
When Finished Sewing
* When you are finished sewing, turn all controls to off (“ О ”)
position, then remove plug from outlet.
* Unplug foot control from machine.
* Lower presser foot lifter.
* Turn handwheel to lower needle bar to the lowest position.
* Place your machine out of reach of children in safe, dry
location.
Operating Instructions:
“For appliances with a polarized plug (one blade
wider than the other). To reduce the risk of electric shock,
this plug is intended to fit in a polarized outlet only one way.
If it does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the
power outlet. Do not modify the plug in any way.”
“Foot Controller Model YC-482J-1 or TJC-150 is used with
Sewing Machine Model 384.18024 XXX.”
XXX - represents numbers 000 through 999.
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
14