To thread the bobbin case – SINGER W150 FL User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3.
TO THREAD THE BOBBIN CASE
Before threading the bobbin case, study Fig, 5, 6, 7,
to get a general idea as to how it is done.
(1)
Hold the bobbin case with your left hand and
put the bobbin into the bobbin case with your
right, leaving about two inches of the thread
end unwound (Fig. 5). As the bobbin is being
inserted in the bobbin case, the THREAD FLOW,
you will note, is CLOCKWISE (Fig. 5).
(2)
While holding the bobbin case os before, grasp
the thread end with your right hand, guide it
into the cross slot (Fig. 6).
(3)
Then pull it through under the tension spring of
the bobbin case (Fig. 6) until it enters the de
livery eye (Fig. 7).
TO THREAD THE BOBBIN CASE
TO REPLACE AND REMOVE THE BOBBIN CASE TO CLEAN SNAP-OPEN RACE
TO THREAD THE MACHINE & NEEDLE TO PREPARE FOR SEWING • TO COMMENCE SEWING
TO REMOVE THE WORK • TO REGULATE THE THREAD TENSION . TO REGULATE THE STITCH LENGTH
TO REGULATE THE PRESSURE OF THE PRESSER FOOT TO USE THE DROP FEED DIAL
BUILT-IN LIGHT
TO OIL SEWING MACHINE
SOME USEFUL SEWING HINTS
CAUSES OF COMMON DIFFICULTIES
NEEDLE AND THREAD^SIZES^