To thread the machine & needle – SINGER W150 FL User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. TO THREAD THE MACHINE & NEEDLE
First, by pulling up the spool pin bring the
spool pin to sewing position and turn the
pulley toward you to raise the needle bar
to Its highest point.
(1)
Place a spool of thread on spool pin.
(
6
' )
(2)
Lead the thread through the arm thread-
guide and down (4) (Fig. 11)
(3)
Run the thread along to the tension
discs from right to left and up.
Then
hang
the
thread
down
to
the
thread take-up spring (18)
Ftg. 11
(4)
Take the thread up through the thread-guide and run the end through the eye
of the thread take-up lever (3) from right to. left.
(5)
Now run the thread down through the thread-guide again and through the
vertical slot and thread-guide at .the lower part of the slot in the face plate
and then through the loop of the needle bar from the back.
(6) Finally, run the end of the thread through the eye of the needle (20) FROM
LEFT TO RIGHT, drawing it through about 3 or 4 inches. You are now ready
to sew.