Casio wk 200 - Manual (Page 20)

Sampling Sounds and Playing Them on the Digital Keyboard
E-18
Use the procedures in this section to sample a sound and play
it as the melody part on the Digital Keyboard.
• Up to five sampled sounds can be stored in Digital
Keyboard memory as tone numbers 671 through 675 (WK-
200: 571 through 575). Simply select the tone number
where the sound you want is located to assign the sound to
the keyboard.
1. Press bp and then use bs (10-key) to enter the
tone number (WK-500: 671 to 675) (WK-200: 571
to 575) where you want to store the sampled
sound.
• In place of the above steps, you could press cs and bp at
the same time and then select a tone number.
2.
Press cs .
This enters sampling standby.
The allowable sampling time (in seconds) will appear on
the display momentarily and then the display will change
to the following.
3.
Output the sound from the external device. In
the case of a microphone, output the sound in
the direction of the microphone.
Sampling will start automatically.
4. After the sound you want to sample is finished,
press
cs .
Sampling will stop when you release cs .
• Even if you do not press cs , sampling will stop
automatically whenever there is no more sound being
input from the external device or microphone. Sampling
also will stop automatically 10 seconds after it is
started.
5.
Play something on the Digital Keyboard.
• You may not be able to get 10 seconds of sampling if
Digital Keyboard memory is low due to storage of other
data. If this happens, deleting other memory data you no
longer need will free up memory space and you should be
able to sample for 10 seconds. See “Deleting a Sampled
Sound” on page E-23 for more information.
• Sampling sound and storing it will delete any sound
data currently stored under the same tone number. To
help ensure that you do not accidentally delete
important data, be sure to read “Protecting Against
Accidental Deletion of Sampled Sounds” on page E-24.
Sampling and Playing a Melody
Sound (Melody Sampling)
To sample a sound
N o D a t a
No sampled sound stored
Lights
W a i t i n g
Flashes
S a m p l i n g
Lights
S 1 : O r g n l
Sampled sound 1
Used memory
(Unit: Kbytes)
Remaining memory
capacity
WK200_e.book 18 ページ ２００８年５月１６日 金曜日 午後８時４４分