Casio wk 200 - Manual (Page 29)

English
Playing Built-in Songs
E-27
You can use the procedure in this section to repeat particular
measures for practice playing along until you master it. You
can specify the start measure and the end measure of the
section you want to play and practice.
1. Press 8 to temporarily turn off song repeat
(“REPEAT” disappears from the display).
2.
When song playback reaches the measure you
want to specify as the start measure, press
8 .
This specifies the measure as the start measure.
3.
When playback reaches the measure you want
to select as the end measure, press
8 again.
This specifies the measure as the end measure and starts
repeat playback of the measures in the specified range.
• During repeat play you can use bl to pause playback,
bk to skip forward, or 9 to skip back.
4. Pressing 8 again returns to normal playback.
Changing the song number clears the start measure and
end measure of the repeat operation.
You can use the following procedure to change the speed
(tempo) in order to slow down playback to practice difficult
passages, etc.
1.
Press bo .
Use y (slower) and t (faster) to change the tempo
setting. Holding down either button changes the setting at
high speed.
• Pressing y and t at the same time will return the
current song to its original default tempo.
• Pressing bo causes the tempo value to flash on the
display. While the tempo value is flashing, you can use
bs (10-key) to change it. The tempo value will stop
flashing if you do not perform any operation for a short
while.
• Changing the song number will return the song to its
original default tempo.
Repeating Playback of Specific Measures
Start End
These measures are repeated.
Flashes
Lights
Changing Playback Speed (Tempo)
WK200_e.book 27 ページ ２００８年５月１６日 金曜日 午後８時４４分