Casio wk 200 - Manual (Page 23)

English
Sampling Sounds and Playing Them on the Digital Keyboard
E-21
5. Output the sound from the external device. In
the case of a microphone, output the sound in
the direction of the microphone.
Sampling will start automatically.
6. After the sound you want to sample is finished,
press
cs .
Sampling will stop when you release cs .
• Even if you do not press cs , sampling will stop
automatically whenever there is no more sound being
input from the external device or microphone. Sampling
also will stop automatically 10 seconds after it is
started.
7.
Press the keyboard key.
• You can repeat steps 3 through 6 to change other sounds
that make up the currently selected drum set. There are
eight sounds per drum set.
• You may not be able to get 10 seconds of sampling if
Digital Keyboard memory is low due to storage of other
data. If this happens, deleting other memory data you no
longer need will free up memory space and you should be
able to sample for 10 seconds. See “Deleting a Sampled
Sound” on page E-23 for more information.
• Sampling a sound will delete any sound data currently
assigned to the same keyboard key. To help ensure
that you do not accidentally delete important data, be
sure to read “Protecting Against Accidental Deletion of
Sampled Sounds” on page E-24.
You can use the procedures in this section to copy the drum
sound assigned to one keyboard key to another key, to
change the pitch of a sound, and to delete a sampled sound.
1. Press bp and then use bs (10-key) to enter the
tone number (WK-500: 676, 677, or 678) (WK-
200: 576, 577, or 578) for the drum set you want.
2. Press cs .
3. Press ct .
This is the editing mode.
• While in the editing mode, you can copy a sound,
change the pitch of a sound, or delete a sound (each of
which is described below). Pressing
ct again exits the
editing mode and returns to step 2 of this procedure.
■ To copy a sampled sound from one key to
another
While holding down the keyboard key to which the sampled
sound you want to copy is assigned, press the keyboard key
to which you want to copy it.
Example: To copy sampled sound of key C4 to key D4
• A keyboard key that already has a sampled sound assigned
cannot be selected as a copy destination.
S a m p l i n g
Lights
S m p l D r m 1
Remaining memory capacity
Editing Sampled Drum Set Sounds
S m p l D r m 1
Flashes at high speed
Indicates keyboard keys that have sounds assigned.
Indicates the keyboard key whose sound was copied.
WK200_e.book 21 ページ ２００８年５月１６日 金曜日 午後８時４４分