Datalogic Scanning C-BOX 200 - Manual (Page 11)

INSTALLATION
2
2.2 OPENING THE DEVICE
To install the C-BOX 200 or during normal maintenance, it is necessary to open it by
unscrewing the four cover screws:
CAUTION
The C-BOX 200 must be disconnected from the power supply
during this operation.
Figure 2 - Opening the C-BOX 200
It is possible to perform the following operations:
• Proceed with the cable connections (see paragraph 2.4.1).
• Set the multiplexer address selection on the rotary switches.
• Mount the C-BOX 200 to a wall or panel.
3