4 version change sensor, Version change sensor – ADLINK aTCA-9710 User Manual

Page 31

Advertising
background image

31

4.1.4

Version Change Sensor

Sensor Type

Sensor
Type
Code

Sensor
Specific
Offset

Event

Version
Change

2Bh 00h




01h


02h

03h

04h

05h

06h


07h

00h Intelligent change detected with associated Entity.
Informational. This offset does not imply whether the
intelligent change was successful or not. Only that a
change occurred.
01h Firmware or software change detected with associated
Entity.Informational. Success or failure not implied.
02h Intelligent incompatibility detected with associated
Entity.
03h Firmware or software incompatibility detected with
associated Entity.
04h Entity is of an invalid or unsupported intelligent
version.
05h Entity contains an invalid or unsupported firmware or
software version.
06h Intelligent Change detected with associated Entity was
successful. (deassertion event means unsuccessful’).
07h Software or F/W Change detected with associated
Entity was successful. (deassertion event means
‘unsuccessful’)
Event data 2 can be used for additional event information
on the type of version change, with the following definition:
Event Data 2
7:0 Version change type

00h unspecified

01h management controller device ID (change in one

or more fields from ‘Get Device ID’)

02h management controller firmware revision
03h management controller device revision
04h management controller manufacturer ID
05h management controller IPMI version
06h management controller auxiliary firmware ID
07h management controller firmware boot block
08h other management controller firmware
09h system firmware (EFI / BIOS) change
0Ah SMBIOS change
0Bh operating system change
0Ch operating system loader change
0Dh service or diagnostic partition change
0Eh management software agent change
0Fh management software application change
10h management software middleware change
11h programmable intelligent change (e.g. FPGA)

12h board/FRU module change (change of a module

plugged into associated entity)

13h board/FRU component change (addition or

removal of a replaceable component on the
board/FRU that is not tracked as a FRU)

14h board/FRU replaced with equivalent version
15h board/FRU replaced with newer version
16h board/FRU replaced with older version
17h board/FRU intelligent configuration change (e.g.

strap, jumper, cable change, etc.)

Advertising