ADLINK aTCA-9710 - Manual (Page 37)

37
5 Getting Started
The aTCA-9710 has been designed for easy installation. However, the following standard
precautions, installation procedures, and general information must be observed to ensure
proper installation and to preclude damage to the board, other system components, or injury
to personnel.
5.1 Safety Requirements
The following safety precautions must be observed when installing or operating the aTCA9710.
ADLINK assumes no responsibility for any damage resulting from failure to comply with these
requirements.
Exercised due care when handling the board as the heat sink can get very hot. Do not touch
the heat sink when installing or removing the board. The board should not be placed on any
surface or in any form of storage container until the board and heat sink have cooled down to
room temperature.
This ATCA blade contains electrostatic sensitive devices. Please observe the necessary
precautions to avoid damage to your board:
„
Discharge your clothing before touching the assembly. Tools must be discharged before
use.
„ Do not touch components, connector-pins or traces.
„ If working at an anti-static workbench with professional discharging equipment, please do
not omit to use it.