ADLINK aTCA-9710 - Manual (Page 47)

47
5.3.3
Update over LAN
The following IPMItool command line parameters are used for communicating with the carrier
IPMC via LAN:
„
-I lan
The parameter instructs the IPMItool utility to use the RMCP protocol for communicating with
the IPMC.
„
-H <IP address >
The parameter specifies the IP address of the IPMC.
Please follow the step to update firmware:
Step1: Prepare an external x86 PC and connect the target aTCA-9710 via BASE Interface.
Put IPMItool and “target image” on the x86 PC with Linux system. Enter the following
command:
Step2: Select “y” and wait until the string of “firmware update procedure successful”
is displayed.
To update other images (BIOS, FRU, etc), just replace the target image and the file name
while typing command.
Item File name
IPMC firmware hpm1fw.img
BIOS hpm1bios.img