ADLINK Express-HL2 - Manual (Page 61)

Express-HL2 Page 61
Feature Options Description
Restore PCIE Registers Enabled
Disabled On non-PCI Express aware OS's (Pre Windows Vista) some devices
may not be correctly reinitialized after S3
. Enabling this restors PCI
Express device configurations on S3 resume . Warning: Enabling this
may cause issues with other hardware after S3 resume .
PEG Configuration (System Agent) Submenu
PCH-PCIe Configuration Submenu
7.3.7.1 PCI and PCIe > PEG Configuration (System Agent)
Feature Options Description
PEG Configuration (System Agen) Info only
PEG0 Not Present Display PEG0 present or not .
PEG0 – Gen X Auto
Gen1
Gen2
Gen3 Configure PEG0 B0:D1:F0 Gen1-Gen3
PEG0 ASPM Disabled
Auto
ASPM L0S
ASPM L1
ASPM L0SL1 Control ASPM support for the PEG Device . This has no effect if
PEG is not the currently active device .
Enable PEG Disabled
Enabled
Auto Enable/Disable the PEG .
Detect Non-compliance Device Disabled
Enable Detect Non-Compliance PCI Express Device in PEG .
PEG Sampler Calibrate Auto
Enabled
Disable Enable/Disable PEG Sampler Calibrate\nAuto means Disabled
for SNB MB/DT, Enabled for IVB A0 B0
.
Swing Control Half
Full Perform PEG Swing Control, on IVB C0 and Later .
PEG Gen3 Equalization Enabled
Disable Perform PEG Gen3 Equalization steps .
Gen3 Eq Phase 2 Auto
Enabled
Disable Perform PEG Gen3 Equalization Phase 2 .
Gen3 Eq Preset Search Enabled
Disable Perform PEG Gen3 Preset Search algorithm, on IVB C0 and
Later
.
PEG RxCEM LoopBack Mode Disabled
Enable Enabled/Disabled PEG RxCEM Loopback Mode .
PCIe Gen3 RxCTLEp Setting 0~7 8 The range of the setting is (0~15) This setting has to be
specified basing on platform design and following the guideline
.