ADLINK Express-HL2 - Manual (Page 69)

Express-HL2 Page 69
7.4 Boot
7.4.1 Boot Configuration
Feature Options Description
Boot Configuration Info only
Setup Prompt Timeout 1 Enable/Disable the onboard SATA controllers .
Bootup NumLock State On Select SATA controller mode .
Quiet Boot Disabled
Enabled
Enable/Disable the PATA port . In fact this enables or disables the
SATA channel on which the onboard SATA to PATA converter is
attached
. When set to enabled the system boot will be delayed for
the time specified in PATA Port Detection Timeout if no PATA
device is connected
.
Auto: Scan for PATA device and enable per default .
Fast Boot Disabled
Enabled Define the maximum time to wait for drive detection on PATA port .
Boot Option Priorities Info only
CSM16 Parameters Submenu
CSM16 Module Version Info only
GateA20 Active Upon Request
Always UPON REQUEST - GA20 can be disabled using BIOS services .
ALWAYS - do not allow disabling GA20; this option is useful when
any RT code is executed above 1MB
.
Option ROM Messages Force BIOS
Keep Current Set display mode for Option ROM .
INT19 Trap Response Immediate
Postponed BIOS reaction on INT19 trapping by Option ROM: IMMEDIATE -
execute the trap right away; POSTPONED - execute the trap during
legacy boot
.
CSM parameters Submenu
7.4.2 CSM parameters
Feature Options Description
Launch CSM Enabled
Disable This option controls if CSM will be launched .
Boot Option filter UEFI and Legacy
Legacy only
UEFI only This option controls what devices system can to boot .
Launch PXE OpROM policy Do not launch
Legacy only
UEFI only Controls the execution of UEFI and Legacy PXE OpROM .
Launch Storage OpROM policy Do not launch
UEFI only
Legacy only Controls the execution of UEFI and Legacy Storage OpROM .
Launch Video OpROM policy Do not launch
UEFI only
Legacy only Controls the execution of UEFI and Legacy Video OpROM .
Other PCI device ROM priority UEFI OpROM
Legacy OpROM For PCI devices other than Network, Mass storage or Video defines
which OpROM to launch
.