ADLINK ETX-BT - Manual (Page 32)

Page 32
6.5 DP Connector
Connector Type: Wurth WE 6871 2214 522
The DP connector brings out DDI1 port of the Intel® Atom™ SoC as either DP or HDMI/DVI on a
flat cable connector.
Pin Definitions
Pin Signal Description (DP / HDMI) Pin Signal Description (DP / HDMI)
1 GND 11 DP_LANE3+ / TMDS1_CLK+
2 DP_LANE0+ / TMDS_DATA2+ 12 DP_LANE3- / TMDS1_CLK-
3 DP_LANE0- / TMDS_DATA2- 13 CONFIG1
4 GND 14 CONFIG2 (not used)
5 DP_LANE1+ / TMDS_DATA1+ 15 GND
6 DP_LANE1- / TMDS_DATA1- 16 DP_AUX+ / HMDI1_CTRLCLK (3.3V !)
7 GND 17 DP_AUX- / HMDI1_CTRDATA (3.3V !)
8 DP_LANE2+ / TMDS_DATA0+ 18 GND
9 DP_LANE2- / TMDS_DATA0- 19 DP_HPD# / HDMI_HPD# !!
10 GND 20 + DP_PWR only (3.3V)
11 DP_LANE3+ / TMDS1_CLK+ 21 + DP_PWR only (3.3V)
12 DP_LANE3- / TMDS1_CLK- 22 + DP_PWR only (3.3V)
6.5.1 Display Mode Selection
Display mode (DP or HDMI/DVI) can be selected by strapping pin 13 (CONFIG1).
Strapping should be done on the carrier as follows
- Pull high to 3.3V (3VS0) for HDMI/DVI
- Pull to GND for DisplayPort mode
6.5.2 Power Output Modification for HDMI
For HDMI/DVI output, pins 16, 17, should be converted to 5V (5VS0) on the carrier by level
shifters
1 22