ADLINK ETX-BT - Manual (Page 34)

Page 34
6.7 GbE Connector
Normal support for 100/10 Mbps LAN is through the X4 connector. There is a build option to
disconnect these signals and instead route full 1000/100/10 Mbps support to the FPC connector
on the module.
Note: Standard modules will not include the FPC connector and
will only route LAN signals to the X4 connector.
Connector Type: FPC-CN-1*20P-RT-D5
Pin Definitions: Pin Orientation
Pin Signal
1 GND
2 LAN_MDI_N3_C
3 LAN_MDI_P3_C
4 GND
5 LAN_MDI_N2_C
6 LAN_MDI_P2_C
7 GND
8 LAN_MDI_N1_C
9 LAN_MDI_P1_C
10 GND
11 LAN_MDI_N0_C
12 LAN_MDI_P0_C
13 GND
14 GBE0_CTREF
15 LED2_1000-L
16 LED2_100-L
17 LED1_LINK/ACT-L
18 NC
19 +V3P3A_LAN
20 +V3P3A_LAN