ADLINK CoreModule 920 - Manual (Page 42)

Chapter 3 Hardware
36 Reference Manual CoreModule 920
Hardware Voltage and Temperature Monitor
The CoreModule 920 provides a hardware monitor to ensure the health of your embedded system with built-
in support for monitoring and control of system temperatures, fan speeds, and critical module voltage levels.
The ADT 7490 Hardware Monitor BIOS setting resides in the Advanced menu of the BIOS setup utility. See
Chapter 4, “BIOS Setup” .
Watchdog Timer
The Watchdog Timer (WDT) restarts the system if a mishap occurs, ensuring proper start up after the
interruption. Possible problems include failure to boot properly, the application software’s loss of control,
failure of an interface device, unexpected conditions on the bus, or other hardware or software malfunctions.
The WDT (Watchdog Timer) can be used both during the boot process and during normal system operation.
• During the Boot process – If the operating system fails to boot in the time interval set in the BIOS, the
system will reset.
Enable the WDT using Watchdog Timer of the Boot menu in BIOS Setup. Set the WDT for a time-out
interval in seconds, between 1 and 255, in one-second increments in the Boot Configuration screen.
Ensure you allow enough time for the boot process to complete and for the OS to boot. The OS or
application must tickle the WDT as soon as it comes up. This can be done by accessing the hardware
directly or through a BIOS call.
• During System Operation – An application can set up the WDT hardware through a BIOS call, or by
accessing the hardware directly. Some ADLINK Board Support Packages provide an API interface to
the WDT. The application must tickle the WDT in the time set when the WDT is initialized or the
system will be reset. You can use a BIOS call to tickle the WDT or access the hardware directly.
• Watchdog Code examples – ADLINK has provided source code examples on the CoreModule 920
Support Software QuickDrive illustrating how to control the WDT. The code examples can be easily
copied to your development environment to compile and test the examples, or make any desired
changes before compiling. Refer to the WDT Readme file on the CoreModule 920 Support Software
QuickDrive.