ADLINK CoreModule 920 - Manual (Page 48)

Chapter 4 BIOS Setup
42 Reference Manual CoreModule 920
• PCH-FW Configuration
 ME FW Version X.X.XX.XXXX
 ME Firmware Mode Normal Mode
 ME Firmware Type Full Sku Firmware
 ME Firmware SKU XMB
• Intel(R)Anti-Theft Technology Configuration
 Intel(R) Anti-Theft Technology [Disabled; Enabled]
 Intel(R) Anti-Theft Technology Rec [X]
 Enter Intel(R) AT Suspend Mode [Disabled]
• USB Configuration
 USB Devices:
X Keyboard, 2 Hubs
 Legacy USB Support [Enabled; Disabled; Auto]
 EHCI Hand-off [Disabled; Enabled]
 USB hardware delays and time-outs:
• USB transfer time-out [1 sec; 5 sec; 10 sec; 20 sec]
• Device reset time-out [10 sec; 20 sec; 30 sec; 40 sec]
• Device power-up delay [Auto; Manual]
• ADT 7490 H/W Monitor
 ADT 7490 Pc Health Status
• Module temperature : +XX C
• ADT7490 temperature : +XX C
• CPU temperature (By PECI) : +XX C
• Vtt : +X.XXX V
• Vccp : +X.XXX V
• Vcc : +X.XXX V
• +5V : +X.XXX V
• +12V : +XX.XXX V
• F81216 Super IO Configuration
 Super IO Chip Fintek F81216
 F81216 Serial Port 1 Configuration
• Serial Port [Disabled; Enabled]
• Device Settings IO=3F8h; IRQ=4;
• Change Settings [Auto;
IO=3E8h; IRQ=7;
IO=3F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;
IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;
IO=3E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;
IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;
IO=2E0h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;
IO=2F0h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12]