ADLINK CoreModule 720 - Manual (Page 11)

Chapter 2 Product Overview
CoreModule 720 Reference Manual 5
Module Features
• CPU
 Provides a 600MHz, 1.3GHz, or 1.6GHz Intel Atom E620T, E660T, or E680T Processor Core and
Graphics Memory Controller Hub
 Provides Enhanced SpeedStep® technology
 Supports Hyper-Threading Technology
 Provides on-die 512-kB, 8-way L2 cache
 Provides L2 Dynamic Cache Sizing
 Supports 32-bit physical addresses and 48-bit linear addresses
 Provides 3D graphics engine
 Provides single-channel DDR2 memory controller
• Memory
 Provides up to 2 GB of +1.8V DDR2 soldered, on-board memory
 Provides double data rate interface
 Supports 32-bit data bus
 Supports DDR2 800MHz memory
 Provides non-ECC, unbuffered memory
• Expansion Buses
 PC/104 (16-bit ISA Bus)
 PC/104-Plus bus speed at up to 66MHz (32-bit PCI Bus)
 PCI 3.0 bus
 I2C 2.1 bus
 Bosch CAN protocol version 2.0B Active
• SATA Interface
 Supports two SATA ports from the EG20T PCH (one used for SSD)
 Provides one standard SATA connector
 Supports on-board Solid State Drive (SSD) with default 8GB capacity
• Serial Interface
 Provides four buffered serial ports (COM0-3), with full handshaking on the COM0 port
 Provides 16550-equivalent controllers with 256-byte FIFO mode on the COM0 port
and 64-byte FIFO mode on the COM1-3 ports
 Supports full-duplex buffering and full status reporting
 Supports full modem capability on COM0 port
 Supports programmable baud-rate generator
• COM0: 300bps to 4Mbps
• COM1, 2, and 3: 300bps to 1Mbps
• CAN Interface
 Supports bit rate up to 1 Mbps
 Supports 32 message objects