ADLINK CoreModule 720 - Manual (Page 7)

CoreModule 720 Reference Manual 1
Chapter 1 About This Manual
Purpose of this Manual
This manual is for designers of systems based on the CoreModule ® 720 Single Board Computer (SBC). This
manual contains information that permits designers to create an embedded system based on specific design
requirements.
Information provided in this reference manual includes:
• Product Overview
• Hardware Specifications
• BIOS Setup information
• Technical Support Contact Information
Information not provided in this reference manual includes:
• Detailed chip specifications (refer to the References section of this chapter)
• Internal component operation
• Internal registers or signal operations
• Bus or signal timing for industry-standard busses and signals
• Pin-signal definitions for industry-standard interfaces
References
The following list of references may help you successfully complete your custom design.
Expansion Bus Specifications
• PC/104 Specification, Revision 2.5, November, 2003
• PC/104-Plus Specification, Revision 2.0, November, 2003
Web site: http://www.pc104.org
• PCI Specification, Revision 3.0, August 12, 2002
Web site: http://www.pcisig.com
• LPC Bus Specification, Revision 1.1, August, 2002
Specification: http://www.intel.com/design/chipsets/industry/25128901.pdf
• PCIe Specification, Revision 1.0a, April 15, 2003
Specification (for members): http://www.pcisig.com/specifications/
• I 2 C Bus Specification Version 2.1
Specification: http://www.nxp.com/documents/other/39340011.pdf
• AMI BIOS Aptio TSE User’s Guide
Data sheet: http://www.ami.com/support/doc/AMI_TSE_User_Manual_PUB.pdf
• Bosch CAN specification version 2.0B
Specification: http://www.can-cia.org/fileadmin/cia/specifications/CAN20B.pdf