ADLINK CoreModule 435 - Manual (Page 17)

Chapter 2 Product Overview
CoreModule 435 Reference Manual 11
Figure 2-5. Header Pin Sequence Identification
J7 – Power Top 10-pin, 0.100" (2.54mm), right-angle header for Power
connection
J8 – GPIO (User) Top 10-pin, 0.079" (2mm) header for User defined GPIO signals
J9 – Serial 2 (COM2) Top 10-pin, 0.100" (2.54mm), right-angle header for Serial 2
interface
J10 – USB0 Top 5-pin, 0.100" (2.54mm), right-angle header for USB0
interface
J11 – Video Top 44-pin, 0.079" (2mm), right-angle header for TTL/VGA
video interface
J12 – Compact Flash Bottom 50-pin, 0.050" (1.27mm) standard socket for Type I or II
Compact Flash cards
J13 – Serial 4 (COM4) Top 10-pin, 0.079" (2mm) header for Serial 4 interface
J14 – Serial 3 (COM3) Top 10-pin, 0.079" (2mm) header for Serial 3 interface
J17 – USB1 Top 5-pin, 0.079" (2mm) header for USB1 interface
J19 – SPI Top 6-pin, 0.100" (2.54mm) header used for data storage
J20 – LPC Bottom 10-pin, 0.050" (1.27mm) female header for LPC expansion
J22 – Gigabit Ethernet LED Top 4-pin, 0.049" (1.25mm) header for Gigabit Ethernet external
LED
J23 – Gigabit Ethernet Top 10-pin, 0.079" (2mm) header for 10BaseT/100BaseTX/
1000BaseT Gigabit Ethernet port
NOTE The pinout tables in Chapter 3 of this manual identify pin sequence using the
following method: A 10-pin header with two rows of pins, using odd/even
numbering, where pin 2 is directly across from pin 1, is noted as 10-pin, 2 rows, odd/
even (1, 2). See
Figure 2-5 .
Table 2-2. Header, Connector, and Socket Descriptions (Continued)
1
2
3
4
5
6
7
8
9
10
10-pin, two rows,
Odd/Even, (1, 2)
CM435_ConNum_a