Gigabit ethernet interface, Table 3-11, Gigabit ethernet interface pin signals (j23) – ADLINK CoreModule 435 User Manual

Page 35

Advertising
background image

Chapter 3

Hardware

CoreModule 435

Reference Manual

29

Gigabit Ethernet Interface

The Gigabit Ethernet solution originates from the 82541PI Gigabit Ethernet controller and consists of both

the Media Access Controller (MAC) and the Physical Layer (PHY) combined into a single component
solution. The Gigabit Ethernet controller is a 64-bit PCIe control unit that features enhanced scatter-gather

bus mastering capabilities, which enable the processor to perform high-speed data transfers over the internal

PCIe bus. The bus master capabilities enable the component to process high-level commands and perform
multiple operations, thereby off-loading communication tasks from the CPU. The Gigabit Ethernet interface

offers the following features:

Full duplex or half duplex support at 10 Mbps, 100 Mbps, or 1000 Mbps

In full duplex mode, the Ethernet controller adheres to the IEEE 802.3x Flow Control specification

In half duplex mode, performance is enhanced by a proprietary collision reduction mechanism

IEEE 802.3 compatible physical layer to wire transformer

IEEE 802.3u Auto-Negotiation support

Fast back-to-back transmission support with minimum interframe spacing (IFS)

IEEE 802.3x auto-negotiation support for speed and duplex operation

3 kB transmit and 3 kB receive FIFOs (helps prevent data underflow and overflow)

On-board magnetics (Ethernet isolation transformer)

Table 3-11

describes the pin signals of the Gigabit Ethernet header which consists of 10 right-angle pins,

two rows, odd/even (1,2) pin sequence, and 0.079" (2mm) pitch.

Note: The shaded table cells denote ground.

Table 3-11. Gigabit Ethernet Interface Pin Signals (J23)

Pin # Signal

Description

1

GND

Ground

2

GND

3

MDI0+ Media Dependent Interface 0 +/-

4

MDI0-

5

MDI1+ Media Dependent Interface 1 +/-

6

MDI1-

7

MDI2+ Media Dependent Interface 2 +/-

8

MDI2-

9

MDI3+ Media Dependent Interface 3 +/-

10

MDI3-

NOTE

The magnetics (isolation transformer, T1) for the Ethernet connector is included
on the CoreModule 435.

Advertising