ADLINK CoreModule 435 - Manual (Page 37)

Chapter 3 Hardware
CoreModule 435 Reference Manual 31
Table 3-13 describes the pin signals of the Video interface, which uses a 44-pin, right-angle header with 2
rows, odd/even sequence (1, 2), and 0.079" (2mm) pitch.
Table 3-13. Video Interface Pin Signals (J11)
Pin # Signal Description
1 TFTDClk TFT Shift Clock – This clock signal provides the timing for transferring digital
pixel data.
2 TFTDE TFT Data Enable – This signal indicates valid data on any of the FP [23:0] lines.
3 TFTLine TFT Line Pulse – This signal is the digital monitor equivalent of HSYNC.
4 TFTFrame TFT Frame Marker – This signal is the TFT monitor equivalent of VSYNC.
5 GND1 Ground 1
6 GND2 Ground 2
7 NC Not connected (FP0 = Flat Panel Data 0)
8 NC Not connected (FP1 = Flat Panel Data 1)
9 FP2 Flat Panel Data 2 – data output, Blue0 (18-bit)
10 FP3 Flat Panel Data 3 – data output, Blue1 (18-bit)
11 FP4 Flat Panel Data 4 – data output, Blue2 (18-bit)
12 FP5 Flat Panel Data 5 – data output, Blue3 (18-bit)
13 FP6 Flat Panel Data 6 – data output, Blue4 (18-bit)
14 FP7 Flat Panel Data 7 – data output, Blue5 (18-bit)
15 NC Not connected (FP8 = Flat Panel Data 8)
16 NC Not connected (FP9 = Flat Panel Data 9)
17 FP10 Flat Panel Data 10 – data output, Green0 (18-bit)
18 FP11 Flat Panel Data 11 – data output, Green1 (18-bit)
19 FP12 Flat Panel Data 12 – data output, Green2 (18-bit)
20 FP13 Flat Panel Data 13 – data output, Green3 (18-bit)
21 FP14 Flat Panel Data 14 – data output, Green4 (18-bit)
22 FP15 Flat Panel Data 15 – data output, Green5 (18-bit)
23 NC Not connected (FP16 = Flat Panel Data 16)
24 NC Not connected (FP17 = Flat Panel Data 17)
25 FP18 Flat Panel Data 18 – data output, Red0 (18-bit)
26 FP19 Flat Panel Data 19 – data output, Red1 (18-bit)
27 FP20 Flat Panel Data 20 – data output, Red2 (18-bit)
28 FP21 Flat Panel Data 21 – data output, Red3 (18-bit)
29 FP22 Flat Panel Data 22 – data output, Red4 (18-bit)
30 FP23 Flat Panel Data 23 – data output, Red5 (18-bit)
31 TFTEnVcc TFT Power Enable
32 TFTEnVee TFT Backlight Enable
33 +PNLVdd Panel Voltage (+3.3 or +5 volts ±5%) depending on setting of JP6
34 +12V Backlight Voltage (+5 or +12 volts ±5%) depending on setting of JP5
35 GND3 Ground 3
36 GND4 Ground 4