ADLINK CoreModule 435 - Manual (Page 19)

Chapter 2 Product Overview
CoreModule 435 Reference Manual 13
Figure 2-7. Header and Socket Locations (Bottom Side)
Jumper Header Definitions
Table 2-3 describes the jumper headers shown in Figure 2-6 .
Note: All jumper headers use .079" (2mm) pitch.
Table 2-3. Jumper Settings
Jumper # Installed Removed/Installed
JP1 – Serial Port 2
Termination Enable RS-485 Termination (Pins 1-2) Disable RS-485 Termination
(Removed) Default setting
JP2 – Serial Port 1
Termination Enable RS-485 Termination (Pins 1-2) Disable RS-485 Termination
(Removed) Default setting
JP5 – Backlight
Voltage Select +5 Volts (Pins 1-2) +12 Volts (Pins 2-3) Default
JP6 – Flat Panel
Voltage Select +3.3 Volts (Pins 1-2) Default +5 Volts (Pins 2-3)
JP7 – Compact Flash
Voltage Select +5 Volts (Pins 1-2) +3.3 Volts (Pins 2-3) Default
JP8 – IDE Select Enable HDD master, CF slave (Pins 1-2)
Default Enable HDD slave, CF master
(Pins 2-3)
CM435_conn_bottom_a
J20
Key:
J12 - Compact Flash
J20 - LPC
J12