ADLINK CoreModule 435 - Manual (Page 2)

Notice Page
DISCLAIMER
ADLINK Technology, Incorporated makes no representations or warranties with respect to the contents of
this manual or of the associated ADLINK products, and specifically disclaims any implied warranties of
merchantability or fitness for any particular purpose. ADLINK shall under no circumstances be liable for
incidental or consequential damages or related expenses resulting from the use of this product, even if it has
been notified of the possibility of such damages. ADLINK reserves the right to revise this publication from
time to time without obligation to notify any person of such revisions. If errors are found, please contact
ADLINK at the address listed below on the Notice page of this document.
Audience
This manual provides reference only for computer design engineers, including but not limited to hardware
and software designers and applications engineers. ADLNK Technology, Inc. assumes you are qualified to
design and implement prototype computer equipment.
ii Reference Manual CoreModule 435
TRADEMARKS
CoreModule and the Ampro logo are registered trademarks, and ADLINK, Little Board, LittleBoard,
MightyBoard, MightySystem, MilSystem, MiniModule, ReadyBoard, ReadyPanel, ReadySystem, and
RuffSystem are trademarks of ADLINK Technology, Inc. All other marks are the property of their
respective companies.
REVISION HISTORY
ADLINK Technology, Incorporated
5215 Hellyer Avenue, #110
San Jose, CA 95138-1007
Tel. 408 360-0200
Fax 408 360-0222
http://www.adlinktech.com
© Copyright 2011 ADLINK Technology, Incorporated
Revision Reason for Change Date
1000 Initial Release Jul/11
1010 Removed PXE Boot, Secondary IDE Master and Slave, SB LPT
Parallel Port, Multi-Finction Ports 1 and 2, Redundancy Control LPT
Port and GPIO Ports 1 and 2 from BIOS setup in Ch 4; changed
IRQ15 default to “Reserved” in BIOS setup;
updated Tech Support addresses in Appendix A
Sept/11