ADLINK CoreModule 435 - Manual (Page 36)

Chapter 3 Hardware
30 Reference Manual CoreModule 435
Gigabit Ethernet External LED Interface
This header provides signals for an external LED that indicates Ethernet links and activity using a single row
of 4 pins with 0.049" (1.25mm) pitch.
Note: The * symbol indicates the signal is Active Low.
Video (TFT/VGA) Interface
The Volari Z9s graphics controller provides two graphics display ports for video signals to a flat panel
display and traditional glass CRT monitor. The features are listed below:
• Enhanced 2D Graphics Accelerator
♦ Full BitBLT implementation for all 256 raster operations
♦ Hardware command queue
♦ Direct Draw accelerator
♦ GDI 2000 accelerator
♦ Supports transparent BitBLT with source and destination keys
♦ Rectangle clipping
♦ Fast line draw engine with styled pattern
♦ Fast rectangle fill engine
♦ 256MB frame buffer with linear addressing
♦ 64x64x2 bit-mapped mono hardware cursor
• VGA Interface
♦ VGA Controller with 135 MHz triple RAMDACs for 1280 x 1024 x 75 Hz display
♦ Supports 24-bit pixel depth
♦ Interlaced or non-interlaced output
• TFT Interface
♦ Conforms with VESA Flat Panel Display Interface FPDI-1B
♦ Supports up to 1600x1200 pixel display resolutions
♦ Uses Internal VGA Controller for display modes settings
♦ Supports 12-, 18-, and dual 12-bit Interface (1 pixel/clock)
Table 3-12. Gigabit Ethernet External LED Pin Signals (J22)
Pin # Signal Description
1 /LINKA* Indicates link connectivity
2 /ACT_A* Indicates transmit or receive activity
3 /LINKA100* Indicates link activity at 100 Mbps
4 /LINKA1000* Indicates link activity at 1000 Mbps