Dialogic SS7G2X - Manual (Page 118)

118
Chapter 6 Command Definitions
6.13.7 SNNAI – SIGTRAN Network Appearance Initiate
Synopsis
This command initiates a relationship between a Network Context and a Network Appearance on a per
SIGTRAN link basis.
See Section 7.2, “Signaling Configuration” on page 136 for a more detailed description of SIGTRAN signaling
configuration.
Syntax
SNNAI: NC =, SNLINK =, SS7MD =, NA =;
Prerequisites
•
The SNLINK has been already initiated.
•
The SS7MD associated with the NC cannot be different to a SS7MD associated with a NC anywhere else
in the system.
•
There is a one-to-one relation between NC and NA on a SNLINK .
•
The NC cannot be the default value for this SNLINK .
•
The SNTYPE of the SNLINK cannot be M2PA.
Attributes
CONFIG
Examples
SNNAI: NC =1, SNLINK =1, SS7MD =ITU14, NA =63;
6.13.8 SNNAE – SIGTRAN Network Appearance End
Synopsis
This command ends a relationship between an NC and NA on a per SNLINK basis.
Syntax
SNNAE: SNLINK =, NC =;
Prerequisites
•
The NC has already been initiated.
•
The SNLINK has already been initiated.
•
There is a configured relationship between NC and NA in this SNLINK .
•
There are no unblocked ASs using this SNLINK and NC combination.
•
If the SNLINK is unblocked, there are NA mapping in other Network Contexts for the SNLINK.
Attributes
CONFIG
Examples
SNNAE: SNLINK =1, NC =1;