Dialogic SS7G2X - Manual (Page 51)

51
Dialogic ® SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.5.5 CNMOI – Configuration Monitor Initiate
Synopsis
This command initiates the monitoring of an object on the Signaling Gateway. An object is currently a
C7LINK .
For signaling, the STS monitors information sent from the EQU of the signaling link and the RTS monitors
information received by the signaling link.
Syntax
CNMOI: C7LINK =, STS =, RTS =;
Prerequisites
•
If specified, the C7LINK has already been initiated and must have a TS and EQU .
•
The PCM on which STS exists must have already been initiated and STS must be within the correct range
for the PCM type (0 to 31 for E1 and 1 to 24 for T1 PCMs).
•
The PCM on which RTS exists must have already been initiated and RTS must be within the correct range
for the PCM type (0 to 31 for E1 and 1 to 24 for T1 PCMs).
•
STS is not already assigned elsewhere on the system for output.
•
RTS is not already assigned elsewhere on the system for output.
•
A signaling link can only be monitored once.
Attributes
CONFIG
Examples
CNMOI: C7LINK =1, STS =3-3-15, RTS =5-3-16;
6.5.6 CNMOE – Configuration Monitor End
Synopsis
This command ends the monitoring of an object. An object is currently only an signaling link.
Syntax
CNMOE: C7LINK =;
Prerequisites
•
The C7LINK is being monitored.
Attributes
CONFIG
Examples
CNMOE: C7LINK =1;