Dialogic SS7G2X - Manual (Page 71)

71
Dialogic ® SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.6.6 C7RTC – CCS SS7 Route Change
Synopsis
This command is used to change the attributes of an SS7 Route. The DPC parameter in this command
supports an extra value ‘DFLT’. When a route is specified as default, messages destined for DPCs within the
network context that have not been configured by the system is sent to the default route.
Syntax
C7RTC: C7RT =, NC =,[ DPC =,][ LS1 =,][ LS2 =,][ LSH =,][ LABEL =,];
Prerequisites
•
If specified, LS2 must have same SS7MD , NI , NC , and OPC as LS1 .
•
If specified, LS1 must have same SS7MD , NI , NC , and OPC as LS2 .
•
The specified route has already been initiated.
•
Any link set specified has already been initiated.
•
The DPC / NC combination (associated with the route’s link sets) must be different for each route.
•
If changing any parameter other than the LABEL , all SS7 signaling links must be blocked.
Note: After blocking, an SS7 link cannot be unblocked until all the boards processing the SS7 signaling
are blocked and then unblocked.
•
Only one default route can be configured per network context.
•
If a default route is specified, a network context cannot be configured with a DPC of 0.
Attributes
CONFIG
Examples
C7RTC: C7RT =1, NC =1, LS1 =2;