Dialogic SS7G2X - Manual (Page 70)

70
Chapter 6 Command Definitions
6.6.5 C7RTI – CCS SS7 Route Initiate
Synopsis
This command is used to initiate an SS7 Route ( C7RT ) to a Destination Point Code ( DPC ) within a Network
Context ( NC ). An SS7 Route utilizes one ( LS1 ) or two ( LS2 ) link sets which route via adjacent point codes to
reach the eventual destination ( DPC ).
On a per network context basis, a default MTP route may be specified. On a per network context basis, traffic
for all point codes not known to the Signalling Gateway are routed to the default route. A default route can
be specified by setting the DPC value on the route to DFLT.
See Section 7.2, “Signaling Configuration” on page 136 for a more detailed description of the SS7 signaling
configuration.
Syntax
C7RTI: C7RT =, DPC =, LS1 =, NC =,[ LS2 =,][ LSH =,][ LABEL =,];
Prerequisites
•
The NC must be the same as the NC of the underlying link sets.
•
The DPC / NC combination must be unique.
•
The link set specified has already been initiated.
•
If the route is to an adjacent point code, then all links in the linkset to that point code must be either
inhibited or blocked.
•
Only one default Route can be configured per Network Context.
•
If a default route is specified, a network context cannot be configured with a DPC of 0.
Attributes
CONFIG
Examples
C7RTI: C7RT =1, LS1 =1, DPC =130, LABEL =ROUTE130;